旋转碰摩板热冲击振动的解析法研究
ANALYTICAL SOLUTION FOR ROTATIONAL RUBBING PLATE UNDER THERMAL SHOCK
-
摘要:提出了热冲击和碰摩故障共同作用下的旋转悬臂板系统动力特性解析解法. 基于变分原理,推导出考虑碰摩力沿宽度方向差异性的薄板系统运动微分方程,将该方程的解分解为热冲击悬臂板准静态解和碰摩薄板热冲击动力解. 通过计算旋转悬臂板的模态特性和温度分布函数,获得了碰摩叶片旋转悬臂板模型的热冲击振动解析解,讨论分析得出热冲击和碰摩故障对薄板振动的影响规律. 研究表明:碰摩振动表现为复杂的多频率耦合振动,高频振动较为显著;热冲击振动表现为简单的低频振动形式,强烈的热冲击导致碰摩薄板趋于低频振动. 碰摩引起的振动形式较热冲击故障更加复杂,更容易引起叶片的破坏. 增大的摩擦系数加剧了碰摩引起的振动,利用减小表面粗糙程度等方法降低摩擦系数,可以达到减小碰摩破坏程度的目的.Abstract:The analysis method is developed to obtain dynamic characteristics of the rotating cantilever plate with thermal shock and tip-rub. Based on the variational principle, equations of motion are derived considering the differences between rubbing forces in the width direction of the plate. The transverse deformation is decomposed into quasi static deformation of the cantilever plate with thermal shock and dynamic deformation of the rubbing plate under thermal shock. Then deformations are obtained through the calculation of modal characteristics of rotating cantilever plate and temperature distribution function. Special attention is paid to the influence of tip-rub and thermal shock on the plate. The results show that tip-rub has the characteristics of multiple frequency vibrations, and high frequency vibrations are significant. On the contrary, thermal shock shows the low frequency vibrations. The thermal shock makes the rubbing plate gradually change into low frequency vibrations. Because rub-induced vibrations are more complicated than those caused by thermal shock, tip-rub is easier to result in the destruction of the blade. The increasing friction coefficient intensifies vibrations of the rubbing plate. Minimizing friction coefficients can be an effective way to reduce rub-induced damage through reducing the surface roughness between the blade tip and the inner surface of the casing.